Standard Barrel
THESE ARE SOME OF THE FINEST PISTOL BARRELS MADE IN THE WORLD!
Because of the care exercised in manufacturing and unwillingness to compromise on any step of the process.
- We use the finest material available (type 416 Stainless Steel)
- Machining processes are accomplished on CNC equipment for close-tolerance production.
- Heat treating is done in a vacuum furnace for clean, consistent hardness of 43-45Rc
- Barrels are bored and rifled using ECM process (electro chemical machining). This process produces greater accuracy (+/- 50 millionths of an inch) and a superior finish (16 RMS or better). It also creates less stress button, broach cutting, resulting in a more accurate barrel with greater durability.
The end result is a good-looking, top-quality barrel with consistent, accurate and long-lasting performance. And don't forget the service. We deal with our customers on a personal level to ensure their complete satisfaction on all of our products.
Threading is available for an extra $60 and will extend the length of the barrel about 1/2". Choosing the threading option makes the barrel a "Special Order" item - please allow extra time to fill your order.
A half-inch extension (no threading) is available for an extra $15. Choosing the 1/2" extension option makes the barrel a "Special Order" item - please allow extra time to fill your order.
***When a barrel contains the word "conversion", it means these barrels work only in 40SW and .357. They will also convert to 9mm.
You cannot go from a 9mm to a 40SW or 357Sig
Yes, you can use the same mag in Glock and Sig Sauer.
***Only in Sig 239 you have to use 9mm to convert
For best results in XD 9mm Conversion, use a 9mm mag.
